PODD – Installation, Operation and Maintenance Manual
A l e n c o n S y s t e m s L L C - P a g e
|
30
Figure 28: PODD Site, Device Command Options
1.
System Reset
– Restarts the Alencon Device and enables Run if in the Shutdown
state.
2.
Shutdown
– Disables power production. The Alencon Device or DCDC must receive
a System Reset command to enable Run.
3.
Precharge
– DO NOT USE
4.
Run
– DO NOT USE
5.
Standby
– DO NOT USE. Puts the Alencon Device into STANDBY mode, Run is
enabled without a System Reset command.
6.
Clear Fault
- This command clears all error flags on the target selected. Note: It is
not necessary to clear faults for the Alencon Device to run.
7.
Test Mode On
– DO NOT USE
8.
Test Mode Off
– DO NOT USE
9.
Set DCDC Frequency
– DO NOT USE
10.
Set Control
–
Main control operations for BOSS (and SPOT in some cases). A sub-
menu of commands are used to choose the Control Mode, Setpoint, Direction (for
BOSS only) and Setpoint Timeout.
Figure 29: PODD Site, Device Command – Set Control
