background image

Visit our website at  

www.alemlube.com.au

 or 

www.alemlube.co.nz

NSW/ACT
TEL: (02) 9677 1555
FAX: (02) 9675 1155

QLD/PNG
TEL: (07) 3204 9166
FAX: (07) 3204 1224

VIC/TAS
TEL: (03) 8787 8288
FAX: (03) 8787 8266

WA
TEL: (08) 9302 4199
FAX: (08) 9303 2095

SA/NT
TEL: (08) 8241 7111
FAX: (08) 8241 7011

NZ
TEL: (64) 9 447 1007
FAX: (64) 9 447 1008

7 of 16

PRE-OPERATION CHECK

CAUTION

Using 2-stroke engine oil could shorten the engines service life. The recommended operating temperature range  

of this engine is 5ºC to 40ºC

1. Place the engine horizontally on a level surface.

2. Remove the oil filler cap and check the oil level.

3. If the level is low, fill to the edge of oil filler hole with the recommended oil

CAUTION

Running the engine with insufficient oil can cause serious engine damage.

5) Check the fuel level.

Remove the fuel tank cap and check if the diesel fuel level is low. Use 0# diesel fuel for summer and 10# diesel fuel for winter.

• Diesel fuel oil is extremely flammable and is explosive under certain conditions.

•  Refuel in a well-ventilated area with the engine stopped. Do not smoke or allow flames or sparks in the refuelling area  

or when diesel oil is stored.

•  Do not overfill the tank (there should be no fuel above the upper limit mark). After refuelling, make sure the tank cap  

is closed properly and securely.

•  Be careful not to spill fuel when refuelling. Spilled fuel or fuel vapour may ignite, if any fuel is spilled, make sure the area is 

dry before starting the engine.

• Avoid repeated or prolonged contact with skin or breathing of vapour.

KEEP OUT OF REACH OF CHILDREN.

• Fuel tank capacity:

• DK80 - 3.5L

 

Using detergent oil or 2-storke engine oil cou
servicelife. 

    The recommended operating temperature range of this engine is 5
1. Place the engine horizontally on a level surface.
2. Remove the oil filler cap and check the oil level.
3. If the level is low, fill to the edge of oil filler hole with the reco

Running the engine with insufficient oil can cause serious engine 
damage 

 
 
 
 

5) Check the fuel level. 

Remove the fuel tank cap andappropriable fuel for the diesel
tank if the fuel level is low. Theis 0# diesel oil (for
dirty diesel oilfuel tanksummer) and

10# diesel oil (for winter). 

and water in the fuel tank. 

 

Diesel oil is extremely flammable and is explosive under certainconditions

 

Refuel in a well-ventilated area with the engine stopped. Do not smoke or allow 
flames orsparks in the refueling area or when diesel oil is stored.

 

Do not overfill the tank (there should be no fuel above the upper limit mark). 
Afterrefueling, make sure the tank cap is closed properly and securely.

 

Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite, if 
any fuelis spilled, make sure the area is dry before starting the engine.

 

Avoid repeated or prolonged contact with skin or breathing of vapor
OFREACH OF CHILDREN. 

 

Fuel tank capacity: 

 

50KB-2: 2.5L 

 

80KB-3: 3 .5L 

storke engine oil could shorten the engine's 

ture range of this engine is 5

  to 40

℃ 

1. Place the engine horizontally on a level surface. 
2. Remove the oil filler cap and check the oil level. 
3. If the level is low, fill to the edge of oil filler hole with the recommended oil 

Running the engine with insufficient oil can cause serious engine 

ppropriable fuel for the dieselcheck the level. Refill the 

oil (forNever use an oil/diesel oil mixture or 

10# diesel oil (for winter). Avoid getting dirt, dust 

Diesel oil is extremely flammable and is explosive under certainconditions 

ventilated area with the engine stopped. Do not smoke or allow 

flames orsparks in the refueling area or when diesel oil is stored. 
Do not overfill the tank (there should be no fuel above the upper limit mark). 

osed properly and securely. 

Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite, if 
any fuelis spilled, make sure the area is dry before starting the engine. 
Avoid repeated or prolonged contact with skin or breathing of vapor. KEEP OUT 

 

 

Using detergent oil or 2-storke engine oil cou
servicelife. 

    The recommended operating temperature range of this engine is 5
1. Place the engine horizontally on a level surface.
2. Remove the oil filler cap and check the oil level.
3. If the level is low, fill to the edge of oil filler hole with the reco

Running the engine with insufficient oil can cause serious engine 
damage 

 
 
 
 

5) Check the fuel level. 

Remove the fuel tank cap andappropriable fuel for the diesel
tank if the fuel level is low. Theis 0# diesel oil (for
dirty diesel oilfuel tanksummer) and

10# diesel oil (for winter). 

and water in the fuel tank. 

 

Diesel oil is extremely flammable and is explosive under certainconditions

 

Refuel in a well-ventilated area with the engine stopped. Do not smoke or allow 
flames orsparks in the refueling area or when diesel oil is stored.

 

Do not overfill the tank (there should be no fuel above the upper limit mark). 
Afterrefueling, make sure the tank cap is closed properly and securely.

 

Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite, if 
any fuelis spilled, make sure the area is dry before starting the engine.

 

Avoid repeated or prolonged contact with skin or breathing of vapor
OFREACH OF CHILDREN. 

 

Fuel tank capacity: 

 

50KB-2: 2.5L 

 

80KB-3: 3 .5L 

storke engine oil could shorten the engine's 

ture range of this engine is 5

  to 40

℃ 

1. Place the engine horizontally on a level surface. 
2. Remove the oil filler cap and check the oil level. 
3. If the level is low, fill to the edge of oil filler hole with the recommended oil 

Running the engine with insufficient oil can cause serious engine 

ppropriable fuel for the dieselcheck the level. Refill the 

oil (forNever use an oil/diesel oil mixture or 

10# diesel oil (for winter). Avoid getting dirt, dust 

Diesel oil is extremely flammable and is explosive under certainconditions 

ventilated area with the engine stopped. Do not smoke or allow 

flames orsparks in the refueling area or when diesel oil is stored. 
Do not overfill the tank (there should be no fuel above the upper limit mark). 

osed properly and securely. 

Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite, if 
any fuelis spilled, make sure the area is dry before starting the engine. 
Avoid repeated or prolonged contact with skin or breathing of vapor. KEEP OUT 

 

UPPER LIMIT MARK

Summary of Contents for DK80

















Reviews: