54
5. ALARM CLOCK
5.1 Introduction:
You may program an alarm (wake-up) time in the WS-3400.
In addition, you may add a frost alert ( ): when it’s colder than -3°C outside, the alarm will sound 30 minutes
earlier than the time you’ve set.
5.2 Alarm time setup:
1. Press and hold the
button at the rear of the indoor unit until the hour display starts flashing and AL
appears in the display.
2. Use
/
to set the hours, briefly press and the minute display starts flashing.
3. Use
/
to set the minutes and briefly press
to save the alarm time.
5.3 Alarm function setup:
1. Briefly press once or multiple times the
button to check or enable/disable the alarm
Only “AL” appears:
the time that is shown is the set alarm time but the alarm itself is switched off
“AL” + “ ” appears:
the alarm is enabled and the alarm signal will sound at the set alarm time
“AL” + “ ” appears:
the frost alarm is set
2. Release the button, after several seconds the actual time is displayed again and the alarm status
remains as described above, visible
5.4 Operation:
•
At the set time the alarm will sound for up to 120 seconds
•
Press the button to stop the alarm sound beforehand OR press the
SNOOZE/LIGHT
button on top
of the indoor unit to switch on the snooze functioning; the wake-up alarm will then sound again after
5 minutes.
•
The alarm is repeated every day until you disable is according to the above instructions.
•
If you’ve enabled the frost alert and it’s colder than -3°C outside, the alarm will sound 30 minutes earlier
than the time you’ve set. If outside it’s warmer than -3°C, the alarm will sound at the set time.
6. MINIMUM AND MAXIMUM MEASURED VALUES
6.1 Introduction:
The measured minimum and maximum values of the following items are saved.
Indoor and outdoor temperature, humidity indoors and outdoors, feels like temperature, heat index, dew
point and wind chill. And additionally the maximum wind speed and gust.
6.2 To view all maximum and minimum values:
Press in the normal mode on the “
MEM
” button to view all maximum and minimum values. The maximum
indoor temperature appears. Repeatedly press the “
MEM
” button for the other items.
6.3 To reset the maximum and minimum values:
While the maximum or minimum value is being displayed, press and hold the “
MEM
” button for 2 seconds
to delete the saved maximum or minimum value. Repeat this for every item to delete all maximum and
minimum values.
