Page 54
May 15, 2012 • Alcorn McBride TourTraXX User’s Manual • Rev 1.3
Paging Commands
Set Paging Zone
Description:
This command sets the channel, channel pair, or channel group that the microphone
is routed to when the paging trigger is activated or a start paging command is
received.
Command Bytes:
Z<d>ZN
Parameters:
<d>
is either
C
followed by a channel number in ASCII,
P
followed by a channel
pair number in ASCII, or
G
followed by a channel group number in ASCII
Comments:
Channel numbers range from 1 through 16, Channel Pairs from 1 through 8, and
Channel Groups from 1 through 13. Use “*” for All Channels.
Minimum OS Version:
TraXXOS 1.2.4
Message Response:
R
Examples:
Set the paging zone to Channel 3.
ZC3ZN
Set the paging zone to Channel Group 2.
ZG2ZN
Set Paging Trigger
Description:
This command specifies which input, front panel button, or push-to-talk will trigger
the microphone to be routed to the set paging zone. Microphone paging will end
when the paging trigger is released.
Command Bytes:
T<t><#>ZN
Parameters:
<t>
is one of the following (in ASCII):
I -
Input
K -
Mic Push-To-Talk Switch
<#>
is the number of the Input
Comments:
If specifying the microphone PTT as the trigger, no <#> field is needed. Input
numbers range from 1 to 8.
Minimum OS Version:
TraXXOS 1.2.4
Message Response:
R
Examples:
Set the microphone PTT button to be the paging trigger.
TKZN
Set rear input #3 to be the paging trigger.
TI3ZN
