Alcatel-Lucent CellPipe 7130, Manual

Page: 145 / 154

A-1 3EQ-10422-AAAA-TCZZA
Edition 01 February 2011
............................................................................................................................................................................................................................................................
A Troubleshooting
Overview
This section identifies common problems that can arise during the use of the CellPipe
7130 RG and offers solutions. Most issues are identified by the LEDs on the front panel of
the CellPipe 7130 RG.
Troubleshooting Table
Symptom Possible cause Solution
Power LED does not
come on after power is
switched on. Outlet, power cord, or power
adapter might be defective.
•
Check the outlet by
plugging in another
electronic device.
•
Call the customer service
number or return the device
to the vendor.
VDSL Link LED
flashes slowly after
connection is
established then it
quickly stats to flash
slowly again. The DSL port on the gateway or
the cable might be defective.
•
Switch the power off and
then switch the power on.
•
Verify that the cable is
connected properly to the
VDSL wall line and the
DSL connector on the
CellPipe 7130 RG.
LAN LED does not
come on after
connection is
established. The LAN port on the
CellPipe
7130 RG
, the network interface
on the computer, or a network
cable may be defective or not
connected.
•
Verify that the power of
CellPipe 7130 RG and
computer are switched on.
•
Ensure that the cable is
plugged into the CellPipe
7130 RG and the device.
•
Check the network adapter
or the cable connections for
defects.