User Manual Albrecht GP 1
15
5.2.8. Activation of the GP LOCATOR position transmission and receive mode
You can select whether or not Your radio shall be able to transmit and
receive positioning data to and from other radio partners. You can recognize
the activated
GP LOCATOR
mode in the
GPS MENU
display. If the display
shows the left picture, the GP LOCATOR is activated.
You can use the following procedure to activate the mode:
•
Switch off
the unit. Press and keep pressed
PAGE
and
PTT
simultaneously, while You
switch on
the unit with the other hand.
Release all buttons. The GP LOCATOR is now activated.
•
To disable
GP LOCATOR
mode follow the same procedure.
5.3. SETUP- Basic settings of the PMR 446 section
This SETUP procedure is only relevant for the PMR section of GP 1. In this chapter You will find the
basic settings, other settings and special, not so often used parameters are described in chapter 8.
•
Start with:
SETUP
PAGE (to obtain SETUP page, press
PAGE
for longer than
1 1/2 seconds
)
•
Select the
RADIO
field with
UP/DOWN
and press
ENTER
.
Radio setup will appear on the display.
•
Any of radio setup options can be accessed using
Up/Down
and press
ENTER
.
You can select to change the following options:
5.3.1. Dual Watch operation
Dual channel is used dual scanning channel. It will be set up to
maximum channel 8.
To change the dual channel
•
Highlight the “DUAL CH” field and press ENTER to select the
available channels.
•
Use the UP/DOWN wheel key to select the channel.
•
Press ENTER.
5.3.2. Calling tones
The transceiver provides 9 user-selectable call ringer melodies (or OFF) to alert you to
an incoming call.
To select your favorite call ringer melody:
•
Highlight the “CALL TONE” and press ENTER to select a call melody
•
Use the UP/DOWN wheel key to select your favorite call melody.
•
Press ENTER.
Note:
It is recommended to switch off the call tones, if the PTT button should not be
easily to be reached, for example on motor bikes.
5.3.3. VOX delay setting
To change VOX delay time
•
Highlight the “VOX DELAY” field and press ENTER
•
Use the UP/DOWN wheel key to select the VOX delay time. (OFF, 01-04 sec)
•
Press ENTER.
We recommend a short delay time for speech and a longer timing for room monitoring
(e.g.baby monitor).
RADIO
D
UAL
C
H
C
ALL
T
ONE
V
OX
D
ELAY
R
OGER
B
EEP
S
Q
T
AIL
DUAL CH
02
Summary of Contents for GP 1
Page 33: ...User Manual Albrecht GP 1 33 ...
Page 34: ...User Manual Albrecht GP 1 34 ...
Page 35: ...User Manual Albrecht GP 1 35 ...
Page 36: ...User Manual Albrecht GP 1 36 ...
