Setup
The
AE180H
comes with a rechargeable Nickel-Cadmium
Battery Pack. When fully charged, this Battery Pack will
supply up to 12 hours of dependable use. (With the
Squelch control in “closed” position.)
Before using the
AE180H
for the first time, or whenever the
LOW BATTERY
Indicator appears on the LCD display, you
should fully charge the Battery Pack.
Note:
When the Battery Pack is low, the Low Battery
Indicator will start to blink. After about 10 minutes, the
scanner will shut itself off to prevent the battery from
becoming completely discharged.
Before charging, you must first install the Battery Pack
according to the steps below.
Charging the Battery Pack
1.
Plug the AC Adapter/Charger (AD-235) into the
Charging Jack located on the left side of the
AE180H
.
You can use the scanner while it is charging.
WARNING! Use only the supplied AC
Adapter/ Charger. Any other AC adapter or
external power plug having over-voltage or
reversed polarity can cause overheating or
damage to the circuitry.
2.
Plug the AC Adapter/Charger into a standard AC outlet.
To fully charge the battery, leave the Adapter/Charger
connected for 14 to 16 hours.
3.
When charging is complete, disconnect the Adapter/
Charger from the AC outlet.
Note:
Disconnect the AC Adapter/Charger from the
unit during a power failure.
Mounting the Flexible Antenna
Place the end of the antenna onto the BNC connector on
top of the scanner and turn clockwise until tight.
10
14
Y:...UB302BH(AE180H).vp
Tue Jul 08 16:23:44 2003
Color profile: Disabled
Composite Default screen
