Albini & Fontanot REFLEX LUX, Assembly Instructions Manual

Page: 11 / 32

11 - Reflex Q
Starting from the top, fit balusters 127002, with parts 033144 and 002040, onto corner treads with a height of 38.
about 99 cm.
Cut a piece of baluster 127010 to length to obtain spacers to connect treads. Insert lateral connection spacers
39.
and secure with components 001013 at top and with part 001001 in part 033144 at bottom.
Cut sections of handrail 140018 to length; assemble with part 046011 placing part 031076 between them. For
40.
optimal fixing, the handrail must follow about 1/8 of a turn from the contact point.
Fix handrail to balusters with parts 002031; keep balusters vertical. Insert angle parts 031061, 031071 and
41.
031072 with screws 012014 and 001017 for changes of direction. Apply end caps 031061 to ends of handrail
with parts 004034 and 011052 (fig. 2) (fig. 12).
Fix component 033142 to the floor using an Ø 8 bit and so that it corresponds to the first baluster. Use elements
42.
002040, 008004, and 001004 (fig. 2). Assemble the reinforcing component (F07).
Determine position of intermediate balusters. Drill with a 4.5 mm bit; assemble parts 033144 with screw
43.
002040.
Cut intermediate balusters at a height that can be determined on the staircase itself. Insert balusters in parts
44.
033144, tighten components 001004 and fix to handrail with parts 002031; keep balusters vertical (fig. 2)
(fig. 12).
Assembly of R020 balustrade
Screw component 033063 onto the 046036 brace with the 011038 screws (fig. 2). Assemble the 121028 post 45.
with the 033149 fixing component and items 011063 and 005036. Insert it into component 033146 and fix it
with the 001004 components, positioning the 033149 tie according to the direction of the handrail.
Position components 033146 on landing, using components 002040 and 001004. Drill landing with a 4.5 mm
46.
bit, keeping a distance between centres of no more than 12 cm.
Position balusters 127004 and tighten component 001004 (fig. 2).
47.
Fix straight handrail 140018 using components 002031 (fig. 2). 48.
Depending on position and presence of walls around the stairwell, it may be necessary to position one or two 49.
extra balusters 127004.
In this case, a space must be considered that is at the same distance from the other balusters or from the wall.
50.
Drill landing with a 5 mm bit and assemble with components 033146, 001004 and 002040 (fig. 2).
Final assembly
To further reinforce the staircase at intermediate points, fix components 033010 to wall and join to the balusters, 51.
using components 033056 and 031066. Drill with an 8 mm bit and use components 008004, 011053, 011057,
005035 (fig. 8) (fig. 10).