Installing Strain Relief Kit
4200-097
18-1
Revision 1.06
18.
Installing Strain Relief Kit
To complete the wiring installation, install the strain relief kit (KIT-1200-378) which is supplied with your
UXTM installation kit. After all wires are connected to the UXTM unit, install the wire routing bracket
behind the wire bundle. The alignment groove on the bracket will mate with the tab on the rear of the
UXTM unit. Move the bracket into place, lifting the wire bundle and secure the bracket with the supplied
mounting screws. The wires should then be routed over the bracket’s edge and secured in place using
the strain relief bracket as shown in the diagram below.
Figure 23 - Installed Strain Relief Kit with Wires Running through Strain Relief Bracket
