32
Display
Fault
Remedy
B33 to
B39
Check electronics, battery pack failure
Switch the system off and then on again.
The battery pack may be defective.
C28
Joystick was extended on start-up
Do not touch the joystick when switching the system on.
I04
Attendant control communication fault
Switch the system off and then on again.
I05
Attendant control button was pressed on start-up
Switch the system off and then on again.
I08,
I09
Attendant control collision protection was activated
Deactivate attendant control.
Switch the system off and then on again.
M10,
M11
Check electronics, drive failure
Switch the system off and then on again.
Swap the two wheels from the left to the right and from
the right to the left-hand side.
M12,
M13
Drive voltage range error
Switch the system off and then on again.
Swap the two wheels from the left to the right and from
the right to the left-hand side.
If the error changes from M13 to M12: Swap the wheels
again.
M14
M15
Drive temperature range error
Reduce your speed.
Let the drives cool down.
Swap the two wheels from the left to the right and from
the right to the left-hand side.
M16 to
M19
Drive overload error
The load is too high for the drives. Prevent overloading.
M20 to
M51
Check electronics, drive failure
Switch the system off and then on again.
Swap the two wheels from the left to the right and from
the right to the left-hand side.
M52
Right drive disengaged
Engage the right wheel.
M53
Left drive disengaged
Engage the left wheel.
M54
Left and right drive disengaged
Engage both wheels
M55,
M56
High drive temperature
Reduce your speed.
Let the drives cool down.
S10,
S11
Cannot communicate with the wheel
Switch the system off and then on again.
Swap the two wheels from the left to the right and from
the right to the left-hand side.
If the error changes from S10 to S11: Swap the wheels
again.
S12
Cannot communicate with the battery pack
Switch the system off, take the control unit plug out
of the battery pack and take the battery pack out of the
interface.
Then insert the battery pack back into the interface and
connect the control unit.
S13
No system communication
Check all plug connections.
S15
Communication was interrupted during travel
Check all plug connections
Switch the system off and then on again.
If an error code appears in the display that is not listed in the table, switch the e-fix off and on again. If an
error is not resolved by doing this, please contact your specialist dealer. Depending on the type of error, the
affected components may need to be sent to Alber for repair.
i
