PM800 Series
IR Transmission Delay
This item allows you to enable/ disable IR transmission delay. This field only configurable if “UART
Mode Select” is set to “ASKIR” or “IrDA”. Options: Enabled (default)
、
Disabled
UR2 Duplex Mode
Select the transmission mode used by the IR interface. Full-duplex mode permits simultaneous
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time.
This field only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”.
Onboard Parallel Port
This item allows you to determine the parallel port interrupt and address.
Options: 378/IRQ7 (default)
、
278/IRQ5
、
3BC/IRQ7
、
Disabled
Parallel Port Mode
This option allows you to select an operating mode for the on board parallel port.
Options: ECP(default) Extended Capabilities Port.
EPP
Enhanced
Parallel
Port.
SPP
Standard Printer Port.
ECP+EPP
ECP & EPP mode.
Normal
EPP Mode Select
Select EPP port type 1.7 or 1.9. Options: EPP 1.7
、
EPP1.9 (default)
ECP Mode Use DMA
Select a DMA Channel for the port. Options: 3 (default)
、
1
Game Port Address
Game Port I/O Address. Options: 201 (default)
、
209
、
Disabled
Midi Port Address
Midi Port Base I/O Address. Options: 330 (default)
、
300
、
290
、
Disabled
Midi Port IRQ
This determines the IRQ that Midi Port will use. Options: 5 (default)
、
7
36
