PM800 Series
Onboard Lan Boot ROM
Decide whether to invoke the boot ROM of the onboard LAN chip.
Options: Enabled
、
Disabled (default)
USB Controller
This option should be enabled if your system has a USB port installed on the system board. You will
need to disable this feature if you add a higher performance controller.
Options: All Enabled (default)
、
All Disabled
USB 2.0 Support
This option should be enabled if your system has a USB 2.0 device installed on the system board. You
will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)
、
Disabled
USB Keyboard Support
Enables support for USB attached keyboard. Options: Disabled (default)
、
Enabled
Super IO Device
If you highlight the literal “Press Enter” next to the “Super IO Device” label and then press the enter
key, it will take you a submenu with the following options:
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you
wish to use it. If you install an add-in FDC or the system has no floppy drive, select “Disabled” in this
field. Options: Enabled (default)
、
Disabled
Onboard Serial Port 1
Select an address and corresponding interrupt for the first serial port.
Options: Disabled
、
3F8/IRQ4 (default)
、
2F8/IRQ3
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto
Onboard Serial Port 2
Select an address and corresponding interrupt for the second serial port.
Options: Disabled
、
2F8/IRQ3 (default)
、
3F8/IRQ4
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto.
UART Mode Select
This item allows you to select the Infra Red (IR) standard to be used.
Option: Normal (default)
、
IrDA
、
ASKIR
。
RxD, TxD Active
This item determines the RxD and TxD frequencies. This field only configurable if “UART Mode Select”
is set to “ASKIR” or “IrDA”. Options: Hi/ Lo (default)
、
Hi/ Hi
、
Lo/ Hi
、
Lo/ Lo
35
