Albalá Ingenieros AAD2000C01, Manual

Page: 13 / 26

Albalá Ingenieros | Manual AAD2000C01
modules using the bus is desired set the corresponding LEFT or RIGHT jumpers to their
ON positions, depending upon the position of the adjacent module with which
communication is desired.
For example, if a mounting frame contains four AAD2000C01 modules that will all share
the internal bus, located in slots 4, 5, 6 and 7: The middle modules in slots 5 and 6 should
have all of their program jumpers set to ON. The module in slot 4 will only have those
jumpers labeled RIGHT set to ON for communication with slot 5, and the module in slot
7 will only have those jumpers labeled LEFT set to ON for communication with slot 6.
3.6. Installing the module in the mounting frame
The following steps should be followed in order to install a AAD2000C01 module in the
mounting frame.
1 - Remove the blank panel covering the front of the empty slot chosen for installing the
AAD2000C01 in the mounting frame.
2 - Insert the AAD2000C01 module into the front of the mounting frame. The edges of
the card slide into two plastic guides inside the mounting frame.
3 - Secure the module to the mounting frame using the two front screws.
After these steps, the module is ready to be connected to other equipment.
13