Albalá Ingenieros AAD2000C01, Manual

Page: 14 / 26

Albalá Ingenieros | Manual AAD2000C01
3.7. Interconnection
The arrangement of the front panel connectors of the AAD2000C01 module is shown in
the following figure.
Front panel of the AAD2000C01
The AAD2000C01 module includes one analog audio input input (IN) and four analog
audio outputs (OUT1 to OUT4).
The front panel has not been designed to support mechanical stress. All cabling in the
rack where the mounting frame is located should be properly supported so that the front
panel does not provide mechanical support.
3.7.1. Analog audio connections
Analog audio inputs are high impedance, balanced and use 3.81mm pitch terminal
block connectors. If another termination resistance is required, a resistor with the
desired termination value can be externally mounted between the + and - terminals.
The analog audio outputs are balanced, use 3.81mm pitch terminal block connectors
and their characteristic impedance is 73Ω.
For analog audio connections two-wire shielded cable is preferred. The GND terminal
allows connection of the cable shield.
14