background image

 

Notices: 

FCC 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 

1. This device may not cause harmful interference. 

and

 

2. This device must accept any interference received, including Interference that may cause 
undesired operation. 

NOTE: Changes and Modifications not expressly approved by Building 36 can void your authority to 
operate this equipment under Federal Communications Commissions rules. 

This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment 
off and on, the user is encouraged to try to correct the interference by one or more of the 
following measures: 

 

Reorient or relocate the receiving antenna. 

 

Increase the separation between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected. 

 

Consult the dealer or an experienced radio/TV technician for help. 

 

IC Notice 

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject 
to the following two conditions: (1) this device may not cause interference, and (2) this device 
must accept any interference, including interference that may cause undesired operation of the 
device. 

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio 
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne 
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage 
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. 

  

 

 

Summary of Contents for Building36 Smart Water Valve








Reviews: