Alamo Industrial Great White M8000MD, Operator'S Manual, Page: 15 / 86

Safety Section 1-12
M-8000MD 12/04
SAFETY
©
2004
Alamo Group Inc.
SAFETY
Maintenance and Service Safety Instructions and Practices
DANGER!
Make sure the PTO shield, integral driveline shields, and input shields are
installed when using PTO-driven equipment. Always replace any shield if
it is damaged or missing.
(S3PT-8)
WARNING!
Never interfere with factory-set hydraulic calibrations. Any change in
calibration could cause a failure of the equipment and may result in injury.
(SBH-13)
WARNING!
Always maintain the safety decals in good readable condition. If the
decals are missing, damaged, or unreadable, obtain and install replace-
ment decals immediately.
(SG-5)
WARNING! Do not modify or alter this Implement. Do not permit anyone to modify
or alter this Implement, any of its components or any Implement
function.
(SG-8)
WARNING!
Periodically inspect all moving parts for wear and replace when neces-
sary with authorized service parts. Look for loose fasteners, worn or
broken parts, and leaky or loose fittings. Make sure all pins have cotter
pins and washers. Serious injury may occur from not maintaining this
machine in good working order.
(SG-21)
WARNING! Your driving vision may be reduced or impaired by the cab, or implement.
Before driving on public roadways identify any limited vision areas, and
make adjustments to your operating position, mirrors, and the implement
transport position so that you can clearly see the area where you will be
traveling, and any traffic that may approach you. Failure to maintain
adequate vision of the public roadway and traffic can result in serious injury
or even death.
(STI-10)
WARNING! Relieve hydraulic pressure prior to doing any maintenance or repair
work on the Implement. Place the Mower Head on the ground or
securely supported on blocks or stands, disengage the auxiliary
hydraulics, and turn off the engine. Push and pull the Control Levers
several times to relieve pressure prior to starting any maintenance or
repair work.
(SPU-34)
WARNING!
Never attempt to lubricate, adjust, or remove material from the Implement
while it is in motion or while the Power Unit engine is running. Make
sure the Power Unit is off before working on the Implement.
(SPU-22)