Alamo Industrial Eagle 14, Operator'S Manual, Page: 150 / 186

OPERATION
Eagle 20 03/09 Operation Section 4-50
© 2009 Alamo Group Inc.
OPERA
T
ION
Clutch Slips Excessively Clutch linings badly worn or Repair clutch per maintenance
plates warped. section of manuals.
Too much power for clutch. Reduce ground speed and material
intake.
Oil on facings. Replace facings.
Friction facings glazed. Clean with emery cloth.
Blade Wears Too Fast Cutting in sandy conditions. Increase cutting height.
Cutting in rocky conditions. Increase cutting height.
Soft "will fit" blades. Use genuine Alamo Industrial HT
blades.
Hydraulic Cylinder Will Not enough pressure. Check pressure.
not Operate Valve not connected properly. Re-plumb valve.
Quick coupler not completely Complete connection.
connected.
Oil Squirting from Oil leaking by piston ring. Do not carry cutter on cylinder. hole
Breather Vent
(A small amount of leakage is (Use stroke collars)
normal)
Piston "O" ring worn Replace piston "O" ring.
Cylinder wall scored or pitted. Replace cylinder.
Wrong piston ring on piston. Use correct piston rings.
Not Cutting Clean Blades dull. Sharpen or replace blades.
Blade rotation incorrect. Use correct blade for carrier rotation.
Carrier RPM too low. Use correct PTO speed and
check for correct gear box ratio.
Cutter not level. Adjust machine.
Tires mashing down grass. Move tires out of cutter overlap
area. Minimum 60" inside tires.
Ground speed too fast. Reduce ground speed.
Blades locked back. Free blades.
Blades riding up due to blade Replace blade bolts.
bolt wear.
Streaking Conditions Conditions too wet for cutting. Allow grass to dry before cutting.
in Swath Blades unable to cut that part of Slow ground speed of tractor but keep
grass pressed down by path of engine running at full PTO rpm. Move
tractor tires. rear tires as wide as possible so wing
blades will pick up grass.
Dull Blades. Sharpen or replace blades.
Height of cutter lower at rear See Cutting Height Instructions.
or front.