AL-KO GP 600 ECO, Translation Of The Original Instructions For Use

Page: 23 / 212

469928_a 23
Help in case of malfunction
10 HELP IN CASE OF MALFUNCTION
DANGER!
Danger of electric shock.
When working on the pump, there is the risk of receiving an
electric shock.
■
Disconnect the mains plug before correcting any malfunc-
tions!
■
Faults in the electrical system must be rectified by a quali-
fied electrician.
Malfunction Possible cause Remedy
Engine does not run. Impeller blocked Remove dirt from the suction area.
Clean through the opening on the
back of the motor housing using a
suitable tool.
Thermal protection switch has
switched off. Wait until the thermal protection
switch on the pump switches on
again. Take note of the maximum
temperature of the conveying me-
dium. Have the pump checked.
No mains power. Check fuses, have the power supply
checked by a qualified electrician.
Pump running but does not
feed. Water level too low. Submerge the suction hose deeper.
Air in pump housing. Fill the pump.
Pump drawing in air. Check all connections and the cover
on the filter for leaks.
Blockage on the suction side. Caution!
Risk of burns from hot
water!
Remove dirt from the suction area.
Pressure line closed off. Caution!
Risk of burns from hot
water!
Open the pressure lone.
Pressure hose kinked. Extend the pressure hose.