AL-KO CSM 1815, Operating Instructions Manual

Page: 40 / 420

GB
40 CSM 1815
Help in case of malfunction
Malfunction Cause Remedy
Engine does not start. Battery is flat. Charge the battery.
Battery missing or not insert-
ed correctly. Install the battery correctly.
Power supply is interrupted. 1. Remove the battery.
2. Clean the plug contacts.
3. Install the battery again.
Motor stops during operation. Too much pressure exerted
on the pruning saw. The
overload protection has
switched off the device. Pull the pruning saw out of the
kerf and switch on again. Exert
less pressure during sawing.
Battery is flat. Charge the battery.
Battery is too hot. Allow the battery to cool down.
Battery is defective. Replace the battery.
Motor keeps cutting out. The ON/OFF switch is defec-
tive. Contact one of the manufactur-
er's service centres.
The chain bar and saw chain be-
come hot when running. Smoke
development. The saw chain is too taut. Check the chain tension. Reten-
sion the saw chain.
Oil tank is empty. Refill with saw chain oil.
The oil entry hole and/or
groove of the chain bar are
dirty. Clean the oil entry hole and
groove of the chain bar.
Motor running, but the saw
chain does not move. The saw chain is too taut. Check the chain tension. Reten-
sion the saw chain.
Appliance fault Contact one of the manufactur-
er's service centres.
Only sawdust is thrown out,
rather than wood chips. The
pruning saw must be forced
through the wood. The saw chain is blunt. Contact one of the manufactur-
er's service centres.
Appliance vibrates unusually. Appliance fault Contact one of the manufactur-
er's service centres.
Foldable chain cover is jammed. Appliance fault Contact one of the manufactur-
er's service centres.
Battery operating time drops
significantly. The service life of the battery
has expired. Replace the battery. Use only
genuine accessories from the
manufacturer.
Battery cannot be charged. Battery contacts are soiled. Contact one of the manufactur-
er's service centres.