AL-KO 3.22 E easy, Translation Of The Original Instructions For Use

Page: 35 / 284

443223_b 35
Help in case of malfunction
9 HELP IN CASE OF MALFUNCTION
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work!
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Malfunction Cause Remedy
Motor does not
start. Cutting blade is blocked.
■
Free the blade of obstructions.
■
Start the lawnmower on short grass.
Cables or switches are defec-
tive. Do not operate the appliance! Contact a
service centre of the manufacturer.
Motor loses power. Cutting blade is blunt. Have the cutting blade sharpened at one of
the manufacturer’s service centres.
Too much grass in the ejector.
■
Remove the grass.
Clean the baffle.
Cutting blade is blunt.
■
Have the cutting blade sharpened at
one of the manufacturer’s service cen-
tres.
Motor stops during
mowing. Motor is overloaded. Switch off the lawnmower, set it on level
ground or short grass and restart.
Grass is wet. Allow the lawn to dry.
Grass catcher is not
filled sufficiently Grass catcher is clogged. Clean the grid of the grass catcher.
Too much grass in the dis-
charge channel or housing.
■
Clean discharge channel / housing.
Correct the cutting height.
Cutting blade is blunt.
■
Have the cutting blade sharpened at
one of the manufacturer’s service cen-
tres.
Cutting height is too low. Increase the cutting height.
Mains cable Cable insulation damaged. Do not operate the appliance! Contact a
service centre of the manufacturer.
10 STORAGE
Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
10.1 Storing the electric lawnmower
1. Switch off the appliance: Remove the safety
key.
2. Set the cutting height to the highest level.
3. Disconnect the mains plug from the mains
power supply.
4. Allow the motor to cool down.
5. Thoroughly clean the device.
6. Rub a thin coat of oil or silicon onto all metal
parts for corrosion protection.
7. Fold down the handlebar.
8. Store the appliance in a dry, clean location
protected from frost. Cover with a breathable
tarpaulin to protect against dust. Do not use
plastic film in order to avoid the accumulation
of moisture.