ENGLISH - 23
To prevent the damage of cable, cable shaping is necessary. By referring the
above image, arrange the cable from the antenna base port straight in 6 cm, and
then bend it to cable holder bottom.
※
13
16
15
Make sure you check and four (4) nuts are
tightened
Fit the supplied nuts to each of the four bolts
and tighten firmly with spanner
Place the antenna on the aluminium plate and
place the washers over each bolt
Parts required, spanner, four(4) nuts
14
6 cm
Connect signal cable to antenna port and place cable holder bottom next to the center of the antenna
base and then apply masking tape 5mm from the outside of the cable holder bottom
19
17
Drill a 35mm hole (or larger) in the centre of the
tape marking
Make sure that hole size is big enough to insert
all cables together by one and one
18
Summary of Contents for EASISAT 4.0
Page 27: ......
