5750H002 Ed.03
14
6.- Configuration
Direct access to alarm levels
To configure the Pre-Alarm and Alarm levels, hold
the
SET
key down for 3 seconds. (Only if
AL1
=1)
Programming menu
Use the programming menu to configure the
various parameters in order to adapt the
transmitter's operation to the requirements of its installation.
Press the
SET
key for 6 seconds to access the programming menu.
IMPORTANT:
If the function of the password has been configured as a keypad block (
b10
=2), or as
an access block to parameters (
b10
=1), you will be requested to enter the access code programmed in
b11
when attempting to access either of the two functions. If the password entered is not correct, the
unit will go back to showing the gas concentration. (See page 11).
Gas concentration
indication
Release
SET
to access
alarm levels
Release
SET
to access
programming
3 s.
6 s.
t
OUT OF
PROGRAMMING
IN
PROGRAMMING
Indication
concentration
Level 1
Menus
Level 2
Parameters
Level 3
Values
Change
value
Change
parameter
Change
menu
OK
OK
OK
OK
OK
10 s.
20 s.
20 s.
Save changes
Do not save changes
It exits the parameter without saving changes,
returns
to
previous
level,
or
exits
programming.
It allows you to scroll through the different
levels, or when setting a parameter, to change
its value.
It allows you to scroll through the different
levels, or when setting a parameter, to change
its value.
It accesses the level shown on the display or,
when setting a parameter, it accepts the new
value.
Operation of the keypad in programming
Summary of Contents for AKO-575 Series
Page 1: ...AKO 575xxx Gas transmitter User manual GB 5750H002 Ed 03...
Page 26: ...5750H002 Ed 03 26...
Page 27: ...5750H002 Ed 03 27...
