AKO AKO-16624, Quick Manual

Page: 17 / 40

1662H411 Ed.06
17 17
Step 1: Cold regulation type
Select the most suitable option based on the type of
installation to be carried out and press
SET . The available
options are shown in the table on the following page.
Step 2: Moisture regulation type
Select the most suitable option based on the type of
installation to be carried out and press
SET . The available
options are shown in the table on the following page.
Step 3: Temperature Set Point
Use keys
N
and
Q
to enter the desired Set Point value
and press SET .
Step 4: Moisture Set Point
Use keys
N
and
Q
to enter the desired moisture Set
Point ( SPH ) value and press SET .
Initial configuration
The first time the unit receives the power supply, it will enter into ASSISTANT mode. The lower display will show the
message
In1 flashing with 0 .
If this is not the first time you run the wizard, after completing the last step the display will show the message
dFp
(default parameters). You may choose between two options:
0: Only change the parameters which affect the wizard. The other parameters will remain the same.
1: All parameters return to their factory setting except those which have been modified by the wizard.
The configuration wizard will not reactivate. To reactivate it, activate the Stand-By mode (by pressing the
m
key
for 3 seconds) and wait until the unit completely halts regulation (the
m
indicator will light up permanently)
and press in this order the following keys (one after the other, not at the same time)
N
,
Q
, SET.
STAND-BY
If the regulation cannot be instantly stopped due to its configuration, a controlled stop process starts
and the
m
icon flashes. To stop the controlled stop process and force the step to Stand-by, press the
Stand-by key again for 3 seconds.
English
AUX
AUX
1
AUX
AUX
2
AUX
AUX
3
AUX
4