10
Complete Preparation
1. Determine the required location for the home power supply cable and drill a ½" (1.3 cm) diameter
hole for wire access.
2. Run ½" (1.3 cm) conduit and wires or home power supply cable according to the National Electrical
Code or CSA Standards and local codes and ordinances. There must be enough ½" conduit and
wires or home power supply cable from the fused disconnect (or circuit breaker) box to make the
connection in the hood’s electrical terminal box.
3. For vented installations only: Using a jigsaw or keyhole saw, cut a 6½" (16.5 cm) diameter hole
for the vent duct.
4. Install air outlet and air outlet gasket (if removed for shipping) with M4*12 screws.
A. Air outlet
B. M4*12 Screw
C. Remove the tape from the flapper
5. Install the exhaust pipe.
