8
Calculating Vent System Length
To calculate the length of the system you
need, add the equivalent feet (meters) for
each vent piece used in the system.
ELECTRICAL
REQIUREMENTS
Observe all governing codes and ordinances.
Ensure that the electrical installation is
adequate and in conformance with National
Electrical Code, ANSI/NFPA 70 (latest
edition), or CSA Standards C22.1-94,
Canadian Electrical Code, Part 1 and C22.2
No. 0-M91 (latest edition) and all local codes
and ordinances. If codes permit and a
separate ground wire is used, it is
recommended that a qualified electrician
determine that the ground path is adequate.
A copy of the above code standards can be
obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
■
A 120 volt, 60 Hz., AC only, 15-amp, fused
electrical circuit is required.
■
If the house has aluminum wiring, follow
the procedure below:
1.Connect a section of solid copper wire to
the pigtail leads.
2.Connect the aluminum wiring to the added
section of copper wire using special
connectors and/or tools designed and UL
listed for joining copper to aluminum.
Follow the electrical connector
manufacturer's recommended procedure.
Aluminum/copper connection must conform
with local codes and industry accepted
wiring practices.
■
Wire sizes and connections must conform
with the rating of the appliance as specified
on the model/serial rating plate. The
model/serial plate is located behind the filter
on the rear wall of the range hood.
■
Wire sizes must conform to the
requirements of the National Electrical Code,
ANSI/NFPA 70 (latest edition), or CSA
Standards C22. 1-94, Canadian Electrical
Code, Part 1 and C22.2 No. 0-M91 (latest
edition) and all local codes and ordinances.
