ropeWater Detector
- 4 -
b)
Now point your browser to the IP address of the unit (default, 192.168.0.100). Next you need
to login as the administrator using your administrator password (default is “public”). You will then
be taken to the summary page.
c)
From the summary page you need to select the sensors tab. The layout of the next page will
vary depending on your unit so please refer to your
unit’s manual.
d)
You should now be able to setup the thresholds for your sensor. The low critical, low warnings,
normal, high warnings, high critical values can be set from this page.
Now we will cover the settings that are specific to your sensor.
Status:
If the sensor is offline, the status is No Status. If the sensor is online, and there is no
water detected, the status is Normal. If water is detected, then the status is Critical. If at any time
communications with the ropeWater sensor are lost, the status of the ropeWater sensor is
changed to Sensor Error.
Configuring the ropeWater sensor on a sensorProbe unit
The ropeWater sensor shows
the “Normal” status in Summery page after connecting the sensor.
Use the Sensors page and the Water Detector sensor settings in the sensorProbes web interface
for configuring the ropeWater sensors settings.
The ropeWater
sensor shows the “Critical” status in the Summery page after detecting water.