ropeWater Detector
- 3 -
o
Up to 8 ropeWater sensors per unit sensorProbe8.
o
Hundreds of ropeWater sensors per securityProbe 5E and E-sensor8 E-modules
o
Full Autosense including disconnect alarm if cut, broken, or disconnected
o
Sensing rope cable can be pre-ordered from a 10 foot minimum to any custom run
length of up to 165 feet or 50 meters.
o
Non-sensing cable comes in a standard 20 foot run length.
o
Can be connected to any of the sensorProbe or securityProbe’s 8 RJ-45 Intelligent
sensor port
s or any of the securityProbe 5E’s E-sensor8 expansion module ports.
o
Can be extended up to 100 feet, or 30 meters using normal CAT5\6 LAN cable from
the RJ-45 sensor ports.
o
Measurement range: Wet or Dry (-20 degrees C- +60 degrees C)
o
Comes fully assembled and includes the rope portion that is the water sensing cable,
the non-sensing area cable (from the rope to the sensing module) and the main
sensing module.
ropeWater sensor product assembly diagram
Configuring the ropeWater sensor
a)
Plug the sensor into one of the RJ45 ports on the rear panel of the unit or expansion module.