Inspection Item
Inspection Point
Remedy
Abnormal wear and crack
on tool
∎ Chisel
∎ Deformed, burred and
worn out chisel should
be repaired.
∎ Excessively worn out tool
needs to be replaced.
Greasing
∎ Grease at start every
2 ~ 3 hours using
the grease pump.
∎ Pump 5~10 times
(Greasing position and
method shown at left.)
∎ When greasing, press
the tool against the
ground.
∎ Grease front head
Level and contamination
of hydraulic oil
∎ Conditions of
hydraulic Oil
∎ Contamination of
hydraulic oil carries
with operating conditions.
The oil color tells the level
of contamination.
∎ Criteria for judging
contamination is
specifically set by AJCE.
∎ When contamination is
excessive, drain and
flush the hydraulic oil
tank and fill it with
a new oil.
Missing rubber pulgs and
snap rings
∎ Rubber plugs
∎ Snap rings
∎ A seriously damaged
part must be replaced.
Summary of Contents for 1000M
