Page 5
Wings
The ailerons hinges are already glued into the wings.
Firmly tug at each hinge point to ensure the hinges are
installed properly.
Carefully locate the aileron servo pocket. (Shining a light
through opposite side of the wing will help highlight the
pocket location.) Use a covering iron and seal the
covering around the edges of the opening before cutting
the covering. Use a new hobby knife blade to cut though
the covering.
Carefully locate the aileron control horn slots. Use a
covering iron to bond the covering in the area the control
horn will sit. Trim the covering away to expose the slots.
Try to avoid cutting into the bulsa surface below the
covering.
Test fit the control horn halves in the slot individually,
then as an assembly. They should fit snug. File the slot if
needed.
Check the alignment of the control horn to the hinge
center line. The linkage hole in the control horn should
be aligned with the hinge centerline.
With the control horn in position apply painter’s masking
tape around the control horn base. Put the tape up to
the base edge. Not under or over it.
