p
p
p
p
,
and alarm time again.
SETTING THE CLOCK
→
D
1 Insert batteries or connect the AC adaptor.
“AIWA” flashes.
2 Keep SET pressed for 1 second.
Days of the week flashes.
3 Press UP or DOWN to set day of the week, then press SET.
MON: Monday/ TUE: Tuesday/ WED: Wednesday/ THU: Thursday/ FRI:
Friday/ SAT: Saturday/ SUN: Sunday
The clock flashes.
4 Press UP or DOWN to set the current time, then press SET.
To change the time faster, keep UP or DOWN pressed.
The clock starts from 00 seconds.
To change the clock setting
Keep SET pressed for 1 second while the clock is displayed.
Days of the week starts flashing, then repeat the procedure from step 3.
To adjust the time for Daylight-saving time
Keep SUMMER TIME pressed for 3 seconds.
appears in the display and the time advances by 1 hour.
When Daylight-saving time ends, keep SUMMER TIME pressed for 3
seconds again.
disappears in the display.
To turn on the back light of the display
When using on the batteries
To turn on the back light of the display, press SNOOZE & LIGHT once.
It lights for about 3 seconds after the last button operation.
When using on the AC house current
Each time SNOOZE & LIGHT is pressed, the display changes as follows.
V
The back light turns on.
V
The back light becomes dim.
V
The back light turns off.
C
DC 6.3V
D
2,3,4
3,4
SUMMER TIME
SNOOZE &
LIGHT
NOTE
FOR USE IN THE U.S.A.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Modifications or adjustments to this product, which are not expressly
approved by the manufacturer, may void the user’s right or authority to
operate this product.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.