AIT HSDV 12.1M3, Operating Manual

Page: 9 / 44

9
Subject to technical amendments without prior notice | 83059300iUK | ait-deutschland GmbH
5.3 Installation
Installation site
IMPORTANT
Only ever install the device inside buildings.
The installation area must be frost-free and dry. It must
fulfil the relevant local regulations.

„Installation plans“, from page 24 and „Dimen-
sioned drawings“, from page 22, for the respec-
tive model
1. Place the device on a stable and horizontal sur-
face, preferably decoupled from structure-borne
noise.
2. Tilt the device slowly and carefully to one side.
3. Secure the tilted device to ensure that it cannot tip
back to its initial position.
4. Fit the adjustable feet ( ① ) to all 3 feet.
1
5. Tilt the device slowly and carefully back to its ini-
tial position.
6. Level out the 3 adjustable feet.
7. If the hydraulic system was dismantled for trans-
port reasons, then it must be screwed back into
place on the tank!
7.1.
IMPORTANT
When mounting the hydraulic system, insert the ca-
ble of the domestic hot water temperature sensor
through its grommet into the support plate. Take care
not to damage the cable.
7.2.
7.3.
7.4.
4x