Required tools for Installation
NO.
TOOI
NO.
TOOI.
1
Screw driver
7
Knife
2
Electric drill, hole
core drill ( 60 mm)
8
Measuring tape
3
Hexagonal wrench
9
Torque wrench
4
Spanner
5
Pipe cutter
6
Reamer
Attached accessories
No.
Accessories part
Qty.
1
Mounting plate
1
2
Air purifying filter (optional)
1
3
Swrews washer dowels
4
4
Unit operation manual
Installation manual
1
1
SELECT THE BEST LOCATION
2
HOW TO FIX INSTALLATION PLATE
There should not be any heat source or steam near the unit.
There should not be any obstacles blocking the air circulation.
A place where air circulation in the room is good.
A place where drainage can be easily done.
Do not install the unit near the door way.
Ensure the spaces indicated by arrows from the wall, ceiling, fence or other obstacles.(Fig 1)
The appliance shall be installed over 2.3m high.
The mounting wall is strong and solid enough to prevent it from the vibration.
The edge of installation carton board should be at more than 50mm at right and left of the wall.
1.Locate the mounting plate on the wall in a horizontal position.
2.Mark the position of the four mounting holes on the wall and drill four holes to accommodate the dowels.
3.Mount the mounting plate on the wall by the four screws. Ensure screws are tightened properly.
4.Mark the location of the piping hole on either side of the mounting plate as shown.
5.The piping hole is drilled at a 5down-ward angle to prevent condensed or rain waler from penetrating back into the room.
6.Trim the hole in the wall with a 70mm commercial plastic tube.
PNV 007
PNV 009
PNV 012
Fig 1-1
