14
1.16
A
B
1
2
3
4
INSTALLATION
The appliance comes with a power cable with a F+E type
plug (CEE 7/7 schuko plug).
The cable can only be replaced by the manufacturer, by the
service centre or by a qualified installer. If using a socket near
the appliance, simply insert the plug.
Before connecting the conditioner check that:
-
The power supply voltage and frequency values
comply with the data plate of the appliance.
- The power supply line has a suitable earth
connection and that it is sized for the maximum
absorption of the conditioner (minimum cable section
equal to 1.5 mm
2
).
-
Power is only supplied using a suitable socket
through the supplied plug.
If the supply cable is replaced, this must be done
exclusively by the technical assistance service or by
authorised personnel and in compliance with current
national regulations.
The appliance must be connected to 230V/50 Hz
mains via an omnipolar switch with a contact opening
distance of minimum 3 mm, or using a device enabling
the complete disconnection of the appliance in
overvoltage III category conditions.
It is possible to carry out the electrical connection using
a cable inside of the wall as indicated in the installation
template (recommended for installations in the upper part
of the wall).
Please check that the power supply is provided with suitable
protections against overloads and/or short-circuits (using
a 10 Amp Time delay fuse or other equivalent devices is
recommended).
To prevent any risk of electrocution, always disconnect the
main circuit breaker before making electric connections or
performing any maintenance on the units.
To carry out direct connections and substitute the power
cord using the cable in the wall, proceed as follows:
-
Remove the upper grill.
- Remove the two plastic side panels, by lifting them
upwards.
-
Undo the front panel fixing screws.
-
Remove the front panel.
-
Disconnect the power cord by unscrewing the 3 screws
from the terminal block.
-
Connect the wall cable, checking that the power supply
line has a suitable earth connection and that it is sized for
the maximum absorption of the conditioner (minimum
cable section equal to 1.5 mm2).
The electrical terminal board, in addition to the connections
required for the power supply, is set up for the connection
of an auxiliary load.
The auxiliary load is activated 75 seconds before the
compressor starts and it is deactivated when the compressor
stops.
The maximum load that can be connected is 1A.
The output is not compatible with motors using starting
capacitors; the installer must check whether the pump
installed is of the electronic type.
Auxiliary Load Power Supply (for external 2-way valves or pumps)
230V/50 Hz Electrical power supply terminal block
Auxiliary load connection
Upper grill
Plastic side panels
Front panel
Fixing screws
Electrical connection
Summary of Contents for AW-XDO009-H11
Page 22: ...22...
