11
WIRING DIAGRAM AND LEGEND
SEE APPENDIX
ELECTRICAL CONNECTIONS
WARNING
Before carrying out any work on the equipment,
make sure that the electrical power supply is
disconnected and that there is no possibility
of the unit being started inadvertently.
Non-compliance with the above instructions
can lead to injury or death by electrocution.
The electrical installation must be performed by a fully qualified electrician, and in accordance with local electrical
standards and the wiring diagram corresponding to the unit model.
Any modification performed without our prior authorisation may result in the unit’s warranty being declared null
and void.
The power supply cable section must be sufficient to provide the appropriate voltage to the unit’s power supply
terminals, both at start-up and under full load operating conditions.
SE3530
models 10 a 90 CMV
SE3531
models 10 a 90 CMV/TBV
SE3532
models 10 a 90 CMV/TBV1
SE3533
models 10 a 90 CMV/TBMV1
SE3534
models 10 a 90 CMV/TBV
SE3535
models 10 a 90 AQUANET
SE3537
models 10 a 90
POWER SUPPLY
All fan coil units are designed for operation under 230 volts, single phase, 50 cycles.
A voltage variation of ± 10 % with regard to nominal voltage 230 V is acceptable.
ELECTRICAL CONNECTIONS
Before making the connections, be sure that the available power supply has the same voltage and phase as that
shown on the fan coil unit nameplate.
Each fan coil unit is supplied with a terminal strip located on the opposite side of piping connections.
Line and low voltage wiring must be done in accordance with electrical code whichever is applicable. Earthing of
unit is imperative.
Manufacturer or its representative cannot be held responsible for accidents resulting from incorrect or non-existent
earthing.
A device to disconnect all the power conductors with an approved minimum opening distance must be included
in the mains power supply according to best installation practices.
Note:
if electrical wiring or conduit comes through the floor, they must be tight along their passage through the
floor.
To perform electrical wiring of the unit, please refer to the wiring diagram pasted
on the unit casing.
Summary of Contents for AHC 10
