Page 58
hELi MODEL TyPE
Using the Trainer Function
1) The Trainer Cable should be connected between the two transmitters and the Trainer function on both transmitters should
be Activated as described previously. Both the Master (Instructor's) transmitter and the Slave (Student's) transmitter should
be turned ON.
will be displayed on the Display screen, indicating that the
transmitter is operating in SLAVE mode.
Activating the Trainer Function - Slave (Student) Transmitter, Continued....
3) Press the INC+/M1 key to change the current transmitter's Trainer
mode to SLAVE. >SLAVE will be displayed.
05.STOP waTch (STOP waTch anD cOUnT UP TiMER)
The Stop Watch function is used to either count down from a programmed Start time (Count Down mode) or to count up from
zero if no Start time is programmed (Count Up mode). In Count Down mode, an audible tone will sound in 1 second intervals
when the Stop Watch reaches 10 seconds from zero. When zero is reached, a long audible tone will sound and the Stop Watch
will begin to count up. In Count Up mode, an audible tone will sound at 1 minute intervals to remind you that the count down time
(zero) has been surpassed.
The Stop Watch function has a number different uses, but one of the more popular uses is to use it as a fuel usage indicator to
remind you to land within an allotted amount of time to ensure that your model doesn't run out of fuel.
Setting the Stop Watch
1) From the Display screen, press the ENTER key to display the Programming Menus.
2) Press the Navigation Pad
56
to highlight STOP WATCH, then press
the ENTER key to display the STOP WATCH menu. The cursor will
default to MIN>00.
2) Turn the receiver ON in the model you're using for training and verify that the Instructor's transmitter controls the model's
control surfaces correctly.
3) Activate the Trainer function by pulling and HOLDING the Trainer switch on the Instructor's transmitter continuously and verify
that the Student's transmitter controls the model's control surfaces correctly.
4) When the Trainer switch is released, the Instructor will have full control over the model. When the Trainer switch is pulled
forward and held continuously, the Student has control over the model. As soon as the Trainer switch is released, the Instructor
will have full control over the model once again.
If using an SD-10G transmitter as the Slave transmitter, to save battery power only the transmitter LCD needs to be
turned ON, using the DISPLAY key.
3) The Minute, Second, and 1/10 Second times can be set independently.
Press the Navigation Pad
56
to highlight the time interval you would
like to program, then press the INC+/M1 or DEC-/M2 keys to set the
desired Start time.
MIN setting range is 0 to 59', SEC setting range is 0 to 59" and 1/10
setting range is 0 to 90. The default setting for each is 0.
