30
TC5-ITA
TC5-ITA rev.02
Room Temperature
This function gives a readout of the current room temperature. Minimum
and maximum temperature values can also be displayed. Internal switch
#5 must be set to ON and a temperature probe must be connected for this
function to work.
If you let the display flash for more than 10 seconds, the con-
troller resets the minimum and maximum temperature values
currently in memory. In other words, the two values are reset
to the current room temperature. To avoid resetting minimum
and maximum values, return to the current opening display
using the adjustment buttons before the 10 second delay has
elapsed.
•
Select "
ROOM TEMPERATURE
" using the function selection buttons.
The current room temperature is displayed.
•
Press the adjustment buttons' up arrow-key once. The maximum
temperature value is displayed alternating with the letters "Hi".
•
Press the adjustment buttons' down-arrow key once. The current
room temperature is displayed once again.
•
Press the adjustment buttons' down arrow-key once again. The
minimum temperature value is displayed alternating with the let-
ters "Lo".
7
TC5-ITA rev.02
INSTALLATION PROCEDURE
Equipment List
Integrating an air inlet control system into your ventilation system requires
the following equipment:
• A Comlink-2 communication module added to your controller
• A TC5-ITA controller for each air inlet panel (up to 100 in all)
• An alarm system (optional)
• A DC power supply (optional)
• A power unit.
Mounting Instructions
Open the latch and lift the cover. Remove the black caps located on each
of the four mounting holes. Mount the enclosure on the wall using four
screws. Be sure the electrical knockouts are at the bottom of the enclo-
sure in order to prevent water from entering the controller. Insert the screws
in the mounting holes and tighten. Fasten the four black caps provided
with the controller onto the four mounting holes. The enclosure must be
mounted in a location that will allow the cover to be completely opened
right up against the wall.
Connections
To connect the equipment, refer to the wiring diagrams enclosed with this
user's manual. Also refer to the DC power supply wiring diagram when
using a DC type motor.
•
Use the electrical knockouts provided at the bottom of the enclo-
sure. Do not make additional holes in the enclosure.
•
Set the voltage switch to the appropriate line voltage.
