ELECTRICAL
G - 12
G
G - 13
DON’TS
1. Don’t force elevating crank up or down. Check for cause of trouble.
2. Don’t rotate directional handle hard against stops.
3. Don’t travel with lift in up position.
4. Don’t leave lift part way up or down.
5. Don’t apply sealing compound or paint over top of base plate or anywhere
on lift.
Lubrication
To lubricate the elevating gear apply a liberal amount of silicone spray lubricant
to the elevating gear with the lift in the down position, then run the lift up and
down a few times to distribute lubricant over gears.
Lubricating Rotating Gear Housing
In the event that rotating the antenna becomes difficult, lubricating the bear-
ing surface between the rotating gear housing and the base plate can restore
normal operation. Any spray type silicone lubricant may be used.
Elevate antenna and remove setscrew from rotating gear housing as shown.
Spray lubricant into hole and around edges of gear housing. Rotate gear hous-
ing until lubricant coats bearing surfaces and antenna rotates freely.
TV Booster/12 Volt Outlet
The TV booster amplifies the signal from the TV
antenna. Pushing the small button activates and
deactivates the booster. A green light comes on
when the booster is activated.
For viewing while
hooked up to an exterior cable or satellite TV
source, turn the booster off.
NOTE: The TV Booster must be on to receive antenna signals and off for
cable or satellite TV operation.
Please review the antenna and booster manuals include in your owner’s
packet before operating the system.
LUBRICATE HERE
SPRAY AROUND EDGES REMOVE SET SCREW
TV Outlet
w/Booster &
12 Outlet
12 V
Outlet
Booster
Switch
TV Cable
Hook Up
Light
Summary of Contents for 2013 SPORT
