G - 4
ELECTRICAL
G - 5
G
12V POWER CIRCUITS
The current in the converter system is 12 volts direct current (12VDC) negative
grounded.
Power sources that supply 12VDC current to the system are as follows:
A. Main charge line from tow vehicle
•
B. Trailer Battery
•
C. Converter
•
The power sources above are all electrically connected to the 12-volt distribu-
tion fuse panel that distributes current to interior branch circuits. The circuits
provide power to operate all 12-volt DC lights and systems.
The power converter is a solid-state electronic power supply and is mainte-
nance free. It is so self-sufficient and quiet that you will probably not know
it is working except for the fact that your battery is always charged, and your
12-volt systems always works. If any 12-volt system fails to operate, first
check your recreational vehicles 12-volt distribution fuse panel located behind
the decorative front door of the converter and inspect all fuses. If a fuse is
opened or blown replace it with the same size fuse (never install a larger use).
If the fuse opens again, have an electrician or certified RV technician locate
the circuit trouble. Replace blown fuses with same type fuses of the proper
amperage only.
If the power converter is not working, first confirm the RV supply or shoreline
cord is plugged into a live circuit. Then check all the 120-volt breakers in your
converter 110 volt distribution panel to make sure they are on. If the breaker is
tripped, follow the instructions to reset the breakers. If the breaker trips again,
consult an electrician or certified RV technician.
CONVERTER OPERATION
The electronic power converter is designed to supply the nominal 12-volt
filtered D.C. power for all 12 volt operated devices encountered in RV service.
Although the converter is an excellent battery charger, the converter does not
require a battery to be connected to it for proper operation.
nOTiCE
: When installing a battery (s) always observe polarity. Connecting a
battery reverse polarity will blow the power converter main fuses located on the
12 volt D.C. distribution fuse block.
120 VOLT AC PANEL BOARD
The AC panel board section of the converter is located behind the converter’s
decorative door. This panel contains the 120 Vac branch circuit breakers for
Summary of Contents for 2013 SPORT
