Mounting the ProST
25
3.
Insert wall anchors (not supplied) into each of the drilled holes.
4.
Align the mounting bracket's four holes with the wall anchors, and then insert a screw (not
supplied) through the mounting bracket holes into each wall anchor, and tighten.
Note: Airspan does not provide screws for attaching the mounting bracket to the wall. The
screw size depends on the structure of the building to which the bracket is to be attached.
When selecting screw sizes, consideration must be given to the weight of the ProST and load
that may be induced in windy conditions.
5.
Attach the ProST to the mounting bracket by performing the following:
a.
Slide an M10-spring lock washer and then an M10-plain washer onto each M10-hex
head screw (ensure lock washer is nearest to head of screw bolt).
b.
Align the mounting bracket's holes with the ProST's mounting holes as displayed below.
(The mounting bracket side that provides a groove for inserting a nut must be aligned
with the ProST's mounting hole that is nearest to the ProST's rear panel.)
c.
From the external sides, insert the M10-hex head screws through the mounting
bracket's holes and ProST's mounting holes. Loosely fasten with the M10-hex nuts.
Summary of Contents for ProST
Page 46: ...605 0000 706 ProST Installation User Guide Rev I 42 ...
Page 58: ...605 0000 706 ProST Installation User Guide Rev I 54 SDA PolyPhaser CPE ...
Page 59: ...Connecting Lightning and Surge Protector 55 SDA 4SDC PolyPhaser CPE ...
Page 64: ...605 0000 706 ProST Installation User Guide Rev I 60 ...
