Connecting to Power
49
CONNECTING POWER CABLE FOR SDA-4SDC
Power Cable Connection
In the SDA-4SDC installation Kit there are two polarized and genderless unassembled Anderson
Powerpole power connectors:
red
for positive connection and black for the negative connection.
Power connectors (Anderson Powerpole)
The power connectors consist of housing (hood and a contact pins). The contact pin is displayed
below:
Housing the Connectors
The power connectors are supplied unassembled. Therefore, you need to crimp the power wires
to the connector's contact pins, and then house them in the Powerpole hood.
Crimping the power wires to the connectors:
1.
Insert the wire into the contact pin's barrel, and then, with a standard crimping tool crimp
the barrel tightly onto the wire (recommended 16 AWG cable wire).
2.
Insert the contact into the hood with the contact's tongue pointing downwards and snap
into place. Ensure that the housing spring mates with the underside of the contact's tongue.
Connecting to the SDA-4SDC
Once you have crimped the power cord to the Powerpole connectors, connect the power
connectors to the SDA-4SDC power receptacles.
To connect the power cord to the SDA-4SDC
Note: The plastic housings are held together with dovetail joints. Always slide these joints
together! They will be damaged if you try to snap them together or apart. They ONLY slide
together in one direction. This should be obvious looking at them carefully.
Summary of Contents for ProST
Page 46: ...605 0000 706 ProST Installation User Guide Rev I 42 ...
Page 58: ...605 0000 706 ProST Installation User Guide Rev I 54 SDA PolyPhaser CPE ...
Page 59: ...Connecting Lightning and Surge Protector 55 SDA 4SDC PolyPhaser CPE ...
Page 64: ...605 0000 706 ProST Installation User Guide Rev I 60 ...
