AirHarmony-4400 (External Cavity Filters) Installation Guide
UGD-D01186
Airspan Commercial and Internal Use
26
Figure 7: Rear External Filters' Set
Note:
The Rear External Filters’ Set come assembled with the M5 pan head screws
holding the external filters in place on the filter bridge.
7.
Align the four screw slots in order to fit the rear external filters’ set in place.
8.
Position the rear external filters’ set on the AirHarmony-4400 in position so the slots on
the sides align with the M5 pan head screws on the unit’s back plate.
9.
Insert all four (4) M5 screws (supplied) and tighten with screwdriver.
Figure 8: Mounting Rear External Filters' set
10.
Loosen the eight (8) M5 screws on the filters to allow easy alignment of with RF
connector.
11.
Align the back bracket (over the rear filter set) and once aligned insert the supplied
M8x20 Hex head bolt with a split washer and a flat washer into each clinch-nut.
