30
Centrox Instruction Manual
AirSep Corporation
5.3
INSTALLATION INSTRUCTIONS
To assure proper installation and safe operation of your Centrox PSA Oxygen
Concentrator, AirSep Corporation recommends that you review this entire section
before you attempt to install the unit.
Do not turn off power to any component unless you are sure the
medical facility does not require any oxygen, or there is a sufficient
alternative/backup source of oxygen.
Before you attempt to install, operate, or repair the oxygen
concentrator, read and thoroughly understand this instruction
manual. Improper operation can result in severe bodily injury,
damage to the system, or poor performance.
Refer to Figure 5.1 as you follow the installation instructions:
1. Place the oxygen concentrator near the inlet of your oxygen distribution
system.
2. Mount both the modules securely to a wall, ensuring that there is a
minimum of two feet between the two modules and minimum of three
feet between the compressor module and a wall. The compressor
module can be on either side of the PSA module.
3. Open the compressor module and remove the tie wrap from each
compressor. The tie wrap holds the compressor to a bracket support
for shipping purpose.
4. Attach the red air hose from the compressor module to the fitting on
the left hand side of the PSA module (See Figure 4.5 and 5.1).
The supply valve assembly at the outlet of the oxygen concentrator
has a small hole drilled in it and allows a controlled amount of flow
during purging process (See Section 6) of the 60 gallon tank (If
supplied).
5. Mount the supply valve assembly (shipped loose) at the outlet of the
PSA module. Refer to Figure 5.1 and 6.1.
6. Attach the main oxygen hose from the supply valve to the inlet of the
oxygen isolation ball valve assembly at the oxygen tank (See Figure
4.5 and 5.1).
7. Attach the regulator-flowmeter assembly at the outlet of the oxygen
receiver.
