4. Troubleshooting
4-15
2. Display of diagnostic trouble code (DTC) by diagnosis lamp
Only when diagnostic trouble code (DTC) occurs during engine operation, diagnosis lamp is ON.
During engine stop, diagnostic trouble code (DTC) displays both present and past diagnostic
trouble code (DTC) by diagnosis lamp blinking pattern (flash code).
3. In case that past diagnostic trouble code (DTC) is memorized
It displays three times memorized trouble code. In case that more than two trouble codes are
memorized, it displays them three times each in numerical order. After they are displayed in one
round, they are displayed in numerical order again. This display continues while diagnosis switch
is being pressed.
4. In case that no diagnostic trouble code (DTC) is memorized
While you pressing diagnosis switch, diagnosis lamp - repeat continuously “the lighting 0.3 seconds
2.4 seconds off”.
5. Reading diagnostic trouble code (DTC) by diagnosis tool
It is possible to read diagnostic trouble code (DTC), using diagnosis tool.
6. List of blinking patterns (Flash codes)
Blinking
pattern
Details
Item to be detected
14
Cam sensor fault (no signal)
Open circuit in sensor/wiring
Cam sensor fault (signal fault)
Broken tooth/unnecessary signal mixed (such as
short circuit with other wiring)
15
Crank sensor fault (no signal)
Open circuit in sensor/wiring
Crank sensor fault (signal fault)
Broken tooth/unnecessary signal mixed (such as
short circuit with other wiring)
16
Cam sensor out of phase
Camshaft gear/crankshaft gear installing angle is
out of phase, or damage in gear
19
Starter cut relay fault
Starter cut relay fault
22
Intake air temperature sensor fault
(low voltage fault)
Short circuit in sensor or harness
Intake air temperature sensor fault
(high voltage fault)
Open/short circuit/deterioration of sensor or
harness
23
Engine coolant temperature sensor fault
(low voltage fault)
Short circuit in sensor or harness
Engine coolant temperature sensor fault
(high voltage fault)
Open/short circuit/breakage of sensor or harness
24
Accelerator sensor 1-2 comparison fault
Opening degree difference between the
accelerator sensor 1-2 45% or more
Accelerator sensor 1 fault (low voltage
fault)
Open/short circuit/breakage of sensor or harness
Accelerator sensor 1 fault (high voltage
fault)
Open/short circuit/breakage of sensor or harness
Accelerator sensor 2 fault (low voltage
fault)
Open/short circuit/breakage of sensor or harness
Accelerator sensor 2 fault (high voltage
fault)
Open/short circuit/breakage of sensor or harness
32
Boost pressure sensor fault (high voltage
fault)
Short circuit in sensor or harness
Discount-Equipment.com
Summary of Contents for PDS400S-6C3
