2. Maintenance
2-5
2.3.2
Change Diaphragm
Speed Regulator (Bellophragm type)
＜
Procedure
＞
①
Remove the speed regulator from the bracket and
disassemble it.
②
Replace diaphragms with new ones.
③
Check A to D shown in figure for any burrs.
④
Diaphragm is delivered in different state from the
state in which it should be installed. So install
diaphragm which should be turned inside out, as
shown in the following Fig.
⑤
Internal face of body and cap and also both internal face and external face of diaphragm should
be coated with molybdenum oxide spray.
How to spray molybdenum oxide paste
：
The areas in oblique line should be sprayed with this
paste.
B
Shaft
Piston
Seal washer
Locking nut
Washer
Diaphragm
[Delivered state]
[State to be installed]
PC06037
A
D
Diaphragm
C
Diaphragm should be rolled up
and back face and piston
should be sprayed.
Then it should be
returned and be sprayed.
Inside of body should
be sprayed.
※
Jointed portion should
be sprayed enough.
Inside face of body
should be sprayed
till middle line.
Discount-Equipment.com
Summary of Contents for PDS185S-6C1
