3
* Motion Report:
When the PIR motion detected, the device will unsolicited to send the report to the nodes in the group 1.
Notification Report (V4)
Notification Type: Home Security (0x07)
Event: Motion Detection, Unknown Location (0x08)
Sensor Binary Report (V2)
Sensor Type: Motion (0x0C)
Sensor Value: 0xFF
* Tamper Report:
Both the 2 tamper keys are pressed over 5 seconds. The device will into the alarm state. In that state, if any one
of the tamper keys be released, the device will unsolicited to send the report to the nodes in the group 1.
Notification Report (V4)
Notification Type: Home Security (0x07)
Event: Tampering. Product covering removed (0x03)
Sensor Binary Report (V2)
Sensor Type: Tamper (0x08) Sensor Value: 0xFF
* Timing Report:
Beside the event triggered could report message, the device also support the timing unsolicited report of the
status.
• Battery level report: Every 6 hours report once in default. It could be changed by setting the configuration
NO. 10.
• Low battery report: When the battery level is too low, every 30 minutes will report once.
Notice: The configuration NO. 10 could be setting to zero to disable the auto report. And the configuration NO.
20 could change the tick interval, the default value is 30, if setting to 1, that means the minimum auto report
interval will be one minute. And please notice if setting this value to zero, that means disable all of the timing
report except the low battery detection.
Power Up Procedure
* Battery Power Check
When the device power up, the device will detect the power level of the battery immediately. If the power level
is too low, the LED will continue flash about 5 seconds. Please change another new battery.
* PIR Warm Up
When the device power on, the PIR need to warm up before the operation. The warm up time about 1 minute,
the LED will flash in every 2 seconds. After finish the procedure the LED will light ON three times.
