PinPoint CDMA User Guide Version 1.0
AirLink Communications, Inc.
Page 35
February 22, 2003
Command
Description
Effective
*CTSE
=n [?]
Clear To Send Enable
n = 0: Disabled (Default).
n = 1: Enable assertion of CTS.
This feature asserts CTS when there is no network
connection.
Note: Flow control (AT\Q) will override this
indication, so if you want to use CTS to indicate no
network coverage, flow control has to be off
(AT\Q0).
RS232 voltage levels: Positive = Network coverage,
Negative = no coverage.
Immediately
(if flow
control off)
*DATE
=[mm/dd/yyyy],[hh:m
m:ss] [?]
Sets and queries the clock in the unit. Either the
date and time can be specified, or simply one of the
two can be specified in which case the unspecified
value will remain unchanged. The date and time
are always specified in UTC (Universally
Coordinated Time) and, as such, the hours are
specified in 24-hours format.
Note that if the product has a GPS (i.e. PinPoints),
the GPS will be used to set the time, in which case
any date/time specified will be ignored.
Immediately
*DATZ
=n [?]
n = 0: Normal Reset (Default).
n = 1: Disable Reset on ATZ.
Immediately
*DNS
n=d.d.d.d
Sets the DNS addresses to be returned during PPP
negotiation. If the underlying communications
network provides DNS addresses, they replace
those specified by this command. *DNS1 and
*DNS2 are valid.
*DPORT
=n [?]
Sets or queries the modem’s Device Port. Valid
values are 0-65535.
Immediately
*DU
=n [?]
Dial UDP Always – Whether the dial command
always uses UDP.
n = 0: dial a normal connection [default]
n = 1: dial UDP always, even when using ATDT
NOTE: When this parameter is set you
cannot
establish a TCP PAD connection.
Immediately
*ENQ
=n [?]
Outputs an ENQ [0x05] after the TCP CONNECT
delayed by the Delay Connect Response time
[S221].
n = 0: Disabled (Default).
n = 1: Enables ENQ on CONNECT.
*NETCHAN
?
Returns the current active channel number.