PinPoint CDMA User Guide Version 1.0
AirLink Communications, Inc.
Page 29
February 22, 2003
Command
Description
Effective
F
n=d.d.d.d [?]
Friends mode IP address
n = Friends list index [1 – 10]
d.d.d.d = IP address to be allowed to access the
modem
255 = allow any number 0-255
Example: 166.129.2.255 allows access by all IPs in
the range 166.129.2.0—166.129.2.255.
Immediately
H
This command does nothing but does not cause an
error either.
Immediately
HOR
=n [?]
Half-Open Response – In UDP auto answer (half-
open) mode:
n = 0: No response codes when UDP session is
initiated
n = 1: RING CONNECT response codes sent out
serial link before the data from the first UDP
packet.
Note: Quiet Mode must be Off.
I
[0]
Returns the product name.
Immediately
I
1
Returns AirLink modem’s firmware version,
hardware ID, and copyright.
Immediately
I
2
Returns the OEM Modem’s firmware version and
relevant hardware ID
Immediately
I
3
Returns the OEM Modem’s unique ID
Immediately
M
This command does nothing but does not cause an
error either.
Immediately
MD
hh [?]
Set or query the modem's default power-up mode
hh (hex byte) =
00 – normal (AT command) mode
01 – SLIP mode
02 – PPP mode
03 – UDP mode (address/port is in S53)
04 – TCP mode (address/port is in S53)
When the modem is power-cycled, it enters the
mode specified by this command, after 5 seconds. If
the mode is 1 or 3, on startup, typing ATMD0
within (about) 5 seconds changes the mode to
normal. Otherwise, it enters SLIP or UDP mode
and no longer responds to AT commands.
5 seconds
OPRG
=n [?]
Enables/disables over-the-air programming of the
modem.
n = 0: Disables over-the-air programming.
n = 1: Enables over-the-air programming.
Immediately