EN
Open and lay
down the upper
main body. Use
(+) screwdriver
to loosen the
cover by
separating screw
from the back
side of the upper
cover and open
the cover. Using
vacuum cleaner
or tightly
squeezed cloth,
clean thoroughly
areas
contaminated
with dusts.
During the process take
care not to wet the
electrical connection or
the motor part located
under fan.
Do not separate fan from
the motor.
Screw for cover
separation (back side of
the upper cover).
Clean the fan cover and
air blowing outlet
around the fan using
brush or vacuum
cleaner. Wash fan cover
by shower afterward.
After cleaning,
following reversal order
of separation, close the
upper part cover by
pushing slightly in the
four places until you
hear the sound “click”.
3.11 Cleaning (Plasma ion generator)
The air-blowing part would be cleaned periodically once in every year.
If the product is used in highly contaminated area, please clean once every 6 months.
Caution: Always disconnect power before cleaning the product.
Using (+) screwdriver, first loosen the screw at the rear part of upper cover and uncover by putting
upward.
Using cotton bud (2) selling at the market, remove dust at the end of electrode (1) with care.
Caution
1. If it is hard to wipe the spot on the lense, clean the lense with a light wet cotton swab. Then
wipe the lense with a dry cotton swab.
2. Do not clean with thinner, benzene or alcohol. It might occur the lense's damage.
3.
After cleaning, reassemble the sensor cover to its original position.
Page 14 of 17
