EN
it after turning it in an anticlockwise direction.
3. By pushing from the front side consecutively, it is easily separable in whole.
Cleaning the Disk Set
Preparation cleaning by water using shower.
Scrub the front and back of the disc with laundry
brush or scrubber using laundry detergent. (If too
much scale occurs, use scale remover.)
After cleaning, rinse with shower water again.
Assembly Order : Axis → Gear disk → Disk (28
pieces) → Gear disk → Cap
Turn cap clockwise until the disc fasten and does
not move. If you use the Easy Kit(Brush), you
can tighten the cap easily.
3.9 Cleaning (pre filter – once a month)
Please clean as following if the air-suction fan and its area are very dirty.
Caution: Always disconnect power before cleaning the product.
Open and lay down
the upper main body.
Hold the handles of
pre-filter and push
toward center to
separate it from the
main body.
Clean the filter using
brush and detergent.
Wash it by shower
afterward.
Assemble the
product in the
reverse order after
cleaning.
3.10 Cleaning (fan area)
Please clean as following when air-suction fan and its area are very dirty.
Caution: Always disconnect power before cleaning the product.
Page 13 of 17
