Air Live FE-501OD, User Manual

Page: 14 / 60

2. Package Contents and Installation
AirLive FE-501OD User’s Manual
10
5 Default Setting
6 Audio In
7 Audio Out
8 CVBS Out
Default Setting: Short Pin4 and Pin5 with a wire PIN
with a short wire to revert to factory default settings.
Break the short when the LED starts quick flashing, and
then camera will reboot automatically a few minutes
later.
Don’t forget to connect
Audio In / Audio Out / CVBS
Out GPIO Pin to GND for active; or leave floating (or
unconnected) to deactivate.
2.3 Install the Camera in LAN
1. Be sure that your PC or laptop has connected to your local Ethernet network.(HUB or
Switch)
2. Be sure that IP Camera has connected to your local networking via the LAN port (RJ45)
on the extension cable. (For PoE model, user can use PoE Switch as power supply)
3. Plug the jack of power adaptor into power jack on the extension cable.
4. Ensure the power adaptor specification matches the power system (110V or 220V) and
plug the adaptor into the outlet(This step is optional if used PoE switch for PoE model)
5. Use AirLive IP Wizard software utility in CD and launch browser to start connecting with
PC.